- Page 1
- Page 2 - Page 3 - Page 4 - Page 5 - Page 6 - Page 7 - Page 8 - Page 9 - Page 10 - Page 11 - Page 12 - Page 13 - Page 14 - Page 15 - Page 16 - Page 17 - Page 18 - Page 19 - Page 20 - Page 21 - Page 22 - Page 23 - Page 24 - Page 25 - Page 26 - Page 27 - Page 28 - Page 29 - Page 30 - Page 31 - Page 32 - Page 33 - Page 34 - Page 35 - Page 36 - Page 37 - Page 38 - Page 39 - Page 40 - Page 41 - Page 42 - Page 43 - Page 44 - Page 45 - Page 46 - Page 47 - Page 48 - Page 49 - Page 50 - Page 51 - Page 52 - Page 53 - Page 54 - Page 55 - Page 56 - Page 57 - Page 58 - Page 59 - Page 60 - Page 61 - Page 62 - Page 63 - Page 64 - Flash version © UniFlip.com |
Innovative Storage Solutions
Braking clip
• regulates flow speed of storage units • avoids product damage due to abrupt stopping at the picking face • blocks individual rollers, thus excerting a slight braking effect onto storage units • for pressure sensitive goods • suited for lanes which accommodate storage units which differ a lot in weight
Price per piece
Finish: galvanised
Dynamic components
27 5 T
Ref.no.
S-25.55 Finish: galvanised Standard length 275 mm= At a pitch of (T) = 28 mm, 10 rollers are covered. At a pitch of (T)= 42 mm, 7 rollers are covered.
Braking rail
• stronger braking effect This 275 mm long steel rail is clipped over several rollers, thus providing a much stronger braking effect than the braking clips.
Price per piece
Ref.no.
S-25.60
Special lengths upon request.
Push-back stop
• prevents storage units from falling down at the loading side due to loads being pushed back unintentionally The push-back stop is mainly used at the loading side. It tilts forward when loads move forward to the picking side. However, if loads are pushed against the flow direction, they are stopped by the push-back stop.
Price per piece, including steel axle
Material: Plastic, colour: black
Ref.no.
S-RSS3
Roller track brace
• prevents that the roller track sides are bent open Required if heavier goods are loaded or in case of rough infeeding of storage units. Finish: galvanised
Price per piece
Protective cap
• for roller track ends Protects from injuries from roller tracks which are not integrated into a flow shelf. Finish: Plastic, colour: black
Price per piece
Ref.no.
S-SPST
Ref.no.
36-28535
25
8
Additional slot stamping
Roller track connector
Joins roller track sections with each other. Allows end-to-end joining to make long lanes.
For bolt-fixing of roller tracks and for end-to-end joining. Suited for M6 to M8 bolts. Ø8 Finish: galvanised
Price per 2 slots
Price per piece, including fixing material
Ref.no.
BL2
Ref.no.
S-RLV1
38
|