- Page 1
- Page 2 - Page 3 - Page 4 - Page 5 - Page 6 - Page 7 - Page 8 - Page 9 - Page 10 - Page 11 - Page 12 - Page 13 - Page 14 - Page 15 - Page 16 - Page 17 - Page 18 - Page 19 - Page 20 - Page 21 - Page 22 - Page 23 - Page 24 - Page 25 - Page 26 - Page 27 - Page 28 - Page 29 - Page 30 - Page 31 - Page 32 - Page 33 - Page 34 - Page 35 - Page 36 - Page 37 - Page 38 - Page 39 - Page 40 - Page 41 - Page 42 - Page 43 - Page 44 - Page 45 - Page 46 - Page 47 - Page 48 - Page 49 - Page 50 - Page 51 - Page 52 - Page 53 - Page 54 - Page 55 - Page 56 - Page 57 - Page 58 - Page 59 - Page 60 - Page 61 - Page 62 - Page 63 - Page 64 - Flash version © UniFlip.com |
www.bito.com
Support clip
Finish: galvanised • provides a safe seat for flow shelves • 5 sturdy hooks accept high load capacities • easy fitting without bolts by inserting the support clip into the upright‘s side perforations • turned through 180°, the support clips allow to adjust flow shelves on a 12,5 mm pitch 1
Ref.no. (per pce) Finish: galvanised Support seats are mostly used at the replenishment side.
S-UV2 2
Support seat
• provides a safe seat for flow shelves Depending on the slope, it is possible that the notch pattern of the flow shelves‘ side sections does not exactly match the position of the support clips, i.e. that there is no notch right over the support clip. In this case, the support seat is pushed over the support clip to provide a safe seat for the flow shelf.
Delivery includes 2 support seats per flow shelf.
Ref.no. (per pce) Finish: galvanised Safety hooks are positioned to act contrary to the tilting direction, i.e. mostly at the replenishment side.
S-AU1 3
Safety hook
• prevents flow shelf tilting • easy assembly without bolts The safety hook is pushed over the flow shelves‘ side section into the side perforations of the uprights.
Delivery includes 2 safety hooks per flow shelf.
Ref.no. (per pce) Finish: Black plastic
S-AHS.4 4
Support clip extension
• gives mid-way support to the flow shelf side sections; for high loads • allows to realise the ideal flow shelf slope by providing an „additional“ pitch of 4.2 mm Pushed over the support clip, the support clip extension allows to create three additional height adjustment options on a 4,2 mm pitch.
There are 2 support clip extensions required per flow shelf.
Ref.no. (per pce) Finish: galvanised Consists of a hexagonal bolt and three nuts.
S-UA5 5
Support bolt
• allows to adjust the picking side of flow shelves almost at floor level height Upright width (SB) FLEX system 60 mm (SF4) PRO system 90 mm (S-P2) 100 mm (S-P3) 120 mm (S-P4 to S-P7) Ref.no. (per pce) S-UBV1 36-26264 36-26265 S-PBV12-2
1 support bolt per upright.
29
PRO system
FLEX system
|