-
7
-
Planetary gearboxes RG
Motor fitting
Step 1
- Remove the protection cap.
- Rotate the gearbox input bush until tightening
screw head is aligned with the access hole of
the flange.
- Loosen the tightening screw.
- Correctly align the motor shaft to the gearbox.
- Fit the motor vertically.
Step 3
- Set torque wrench to measure tightening
torque value as shown.
- Tighten clamp screw as listed.
-
VC screw type
:
Socket-head screw
(Allen screw).
[Nm]
12.9
M4 4.9
M5 9.7
M6 16
M8 40
M10 77
Screw
diameter
Step 2
- Apply anti-loosening paste (Loctite 243 or similar)
on screw thread.
- Tighten the screws according to table torque val-
ues.
- Screw resistance class:
recommended 12.9
Step 4
- Reset the protection plug.
Screw class
12.9
Type
[Nm]
RG 051/052
VC 4.12
4.9
RG 071/072
VC 5.20
9.7
RG 091/092
VC 6.30
16
RG 121/122
VC 8.40
40
Gearbox
type