E-Z Burr Brochure Page 13

To Replace the Carbide Insert

And Quick Insert Replacement

The carbide system uses the same patented locking system as the HSS series,
enabling you to change inserts in just seconds with the tool still in the machine.
All it takes is one-eighth turn. Just follow these four steps for easy replacement.

To Remove the Carbide Insert

With the flex arm at its most extend-
ed position, engage the slot of the
insert over the tip of the flex arm.

Carefully slide the end of the insert back
into the arbor slot until the flex arm is
lowered into position. Lock the flex arm
back into place with a simple 1/8 clock-
wise turn of the locking screw.

Unlock the flex arm with a simple
1/8 counterclockwise turn of the
locking system.

Once in the unlocked position the
insert can be pulled up and out of
the holder.