9 SECTION STEERING & SUSPENSION universal knuCkle spreader tool kit Model No. Description • Used to Spread the Steering knuckle to Enable the Removal and Refitting of Shock Absorbers Without the risk of Damage to the aluminium or cast Iron Knuckle • Suitable for Steering Knuckles with Either a Centralised slot or a non Centralised Slot SP70970 universal knuCkle spreader master kit Model No. Description • Suitable for removal and Installation of Spring and Shock Strut from Steering Knuckle • Prevents Expensive Damage to Aluminium or cast Iron Steering Hubs • Excellent also for Spreading the Clamp on lower Ball Joints • Wide Range of Vehicle Applications SP70972 WishBone lever tool Model No. Description • To push down the wishbone and other suspension parts, e.g. during the disassembly of the drive shaft, during replacing the gaiter or exchange of the wheel bearing • After loosening the ball joint the wishbone must in most cases be pushed down against the bush or stabilizer tension, in order to pull the joint from the support SP70975 tie rod separator Model No. Description • For use on Most cars and light Trucks to Remove tie rods from shock Absorber Links Ball Joint • Constructed of Drop-Forged Steel for long-lasting Strength and Durability • Fork size: 19mm (16’’), Length: 400mm SP67020 Ball Joint separator Model No. Description • For use on most cars and Light Trucks to remove ball Joint from steering knuckles • Constructed of Drop-Forget Steel for Long-Lasting Strength and Durability • Fork Size: 24mm (12’’), Length: 300mm SP67021 192 SP Tools Catalogue, © Copyright 2014 www.sptools.com